Unknown - page 1291

G045
User´s Guide
Tungaloy
User ’s
Gu ide-
Techn i ca l Reference
Poor surface
finish
Chattering
Bright, but Wavy surface
Small chips are welded on
surface.
Scratches on the surface
Poor surface by over cutting
Finish size becomes a minus
tendency.
Poor straightness
¡
Reduce feed per tooth.
¡
Increase flutes; E.g. 2 flutes
/
3flutes, or 4flutes.
¡
Increase cutting speed.
¡
Use coolant or air blast, or increase coolant.
¡
Make slight honing on the edge.
¡
Upward milling
/
Down cutting.
¡
Increase feed per tooth. Increase Depth of Cut.
¡
Make slight honing on the edge.
¡
Use non-water soluble coolant.
¡
Down cutting
/
Upward milling.
¡
Reduce depth of cut.
¡
Increase cutting speed.
¡
Reduce feed per tooth.
¡
Upward milling
/
Down cutting.
¡
Reduce depth of cut.
¡
Replace chuck or collet to new one.
¡
Reduce overhang length.
¡
Increase cutting speed.
¡
Reduce depth of cut.
¡
Replace chuck or collet to new one.
¡
Reduce overhang length.
¡
Increase cutting speed.
¡
Increase flutes; E.g. 2 flutes
/
4flutes.
¡
Reduce feed per tooth.
¡
Check the edge. Change tool, when needed.
¡
Increase feed per tooth.
Reduce feed per tooth, when current feed is more than 0.07 mm/t.
¡
Change cutting speed.
¡
Replace chuck or collet to new one.
¡
Reduce overhang length.
¡
Use 2 flutes tool in roughing. Use 4 flutes tool in finishing.
¡
Down cutting
/
Upward milling.
Poor accuracy
Trouble
Possible causes
Sol id Carbide Endmi l ls
Countermeasures
1...,1281,1282,1283,1284,1285,1286,1287,1288,1289,1290 1292,1293,1294,1295,1296,1297,1298,1299,1300,1301,...1348
Powered by FlippingBook