G041
User´s Guide
Tungaloy
User ’s
Gu ide-
Techn i ca l Reference
Rapid wear of
cutting edge
Rapid chipping of
cutting edge
Fracturing
Excessive chip
welding or build-up
on cutting edge
Rough finish
• Improper insert grade selection
• P30 (Cemented carbide)
/
Cermet, coated grade (For steels)
(Insufficient wear resistance)
• K10 (Cemented carbide)
/
Coated grade (For cast irons)
• Excessive cutting speed
• Select cutting speed suited for Workpiece material and insert grade
• Inadequate feed
• Use standard cutting condition in catalog as guide
• Improper Insert grade selection (Insufficient toughness) • Cermet
/
P30 (For steels), K10
/
K20 (For cast irons)
• Cutting hard material and
• Decrease cutting speed
unfavorable surface condition
• Use cutter with strong cutting edge
• Excessive feed
• Proper selection of feed conditions, using recommended cutting conditions in catalog as guide
• Excessive pressure applied on cutting edge • Proper selection of engaging angle
• Machining superalloys
• Use a negative-positive type cutter with large corner angle
• Cracking due to thermal shock
• Select insert grade of stronger thermal shock resistance
• Decrease cutting speed
• Continuous use of excessively worn insert • Shorten replacement standard time of insert
• Cutting hard material
• Use cutter with stronger cutting edge
• Use cutter of larger corner angle
• Obstruction to chip flow
• Use cutter with better chip expulsion
• Recutting of chips after chip welding
• Select insert grades difficult for chips to adhere
Cemented carbides
/
cermets, coated grades
• Use air blow
• Excessively slow cutting, too fine feed
• Select cutting speed and feed optimized for insert grade and
Workpiece material
• Cutting soft material such as aluminium, copper, mild steel
• Use cutter with large rake angle
• Cutting stainless steel
• P30
/
coated grades (AH130
、
AH3135)
• Use of cutter with negative rake
• Use cutter with large rake angle
or too small rake angle
• Effect of built-up edge
• Increase cutting speed
• Appropriate cutting depth (finish allowance)
• Change insert grade For steels : P
/
coated
/
cermet
For cast irons : K
/
coated
• Effect of face cutting edge run out
• Proper installing of inserts
• Use insert of high dimensional accuracy
• Cleaning of insert pocket
• Continuous use of excessively worn insert • Shorten replacement standard time of insert
• Remarkable feed marks
• Feed per revolution to be set within flatland width
• Use wiper insert type cutter such as T/EAW13
• Use cutter exclusively for finishing
• Unstable clamping of workpiece
• Check clamping method of workpiece
• Cutting of welded construction of
• Adopt cutter of large rake angle and small corner angle
thin steel plate
• Excessive cutting condition
• Re-examine allowable chip removal rate according to motor HP
• Face milling of narrow width workpiece
• Use cutter of small cutter diameter and with many teeth
• Too many simultaneous cutting teeth engagement
• Reduce No. of teeth or adopt irregular pitch cutter
Chattering
Trouble
Possible causes
Countermeasures
Trouble shoot ing in face mi ll ing
Mi l l ing Tool s