G044
User´s Guide
User ’s
Gu ide-
Techn i ca l Reference
Fracture on
cutting edge
Large wear in
short time
¡
At the start of machining
¡
At the end of machining
When usual machining
When change the direction
of feed
Chipping on corner edge
Chipping on boundary part
Chipping on central part or
all edges.
Fracture on cutting edge
¡
Reduce feed.
¡
Reduce tool overhang length.
¡
Exchange to short cutting edge tool.
¡
Reduce feed.
¡
Managing tool life
/
Exchange in shorter time.
¡
Replace chuck or collet to new one.
¡
Reduce tool overhang length.
¡
Make optimum honing on the edge.
¡
Reduce flutes. E.g. 4 flutes
/
3flutes, or 2flutes.
¡
Use enough coolant. Change direction of supplying coolant.
¡
Use the circular interpolation in NC machine. Stop feed shortly before changing.
¡
Lower feed around changing part.
¡
Replace chuck or collet to new one.
¡
Chamfer the corner with hand-stick grinder.
¡
Down cutting
⇒
Upward milling.
¡
Change cutting direction, Down cutting
/
Upward milling.
¡
Reduce cutting speed.
¡
Make slight honing on the edge. Or make honing bigger.
¡
Change spindle revolution number.
¡
Increase cutting speed.
¡
If chattering, increase feed.
¡
Use coolant or air blast.
¡
Replace chuck or collet to new one.
¡
Decrease cutting speed.
¡
Decrease feed.
¡
Reduce flutes. E.g. 4 flutes
/
3flutes, or 2flutes.
¡
Make slight honing on the edge. Or make honing bigger.
¡
Replace chuck or collet to new one.
【
For Solid carbide endmill
】
¡
Decrease cutting speed.
¡
Use enough coolant. Change direction of supplying coolant.
¡
Decrease cutting speed.
¡
Change cutting direction, Upward milling
/
down cutting.
¡
Increase feed.
¡
Use coolant or air blast.
¡
In reground tool, grind flank face with FINER wheel.
Breakage
(In case of solid
carbide endmill and
brazed endmill with
small diameter)
(Continued on next page)
Troubl e shoot ing in Endmi l l ing
Trouble
Possible causes
Sol id Carbide Endmi l ls
Countermeasures