G051
User´s Guide
Tungaloy
(
ø
22,
V
c
= 100 m/min,
f
= 0.1 mm/rev )
(
ø
22,
V
c
= 160 m/min,
f
= 0.08 mm/rev )
f
= 0.07 mm/rev
f
= 0.13 mm/rev
f
= 0.1 mm/rev
User ’s
Gu ide-
Techn i ca l Reference
Stainless steel (JIS SUS 304)
Mild steel (JIS SS400)
DS
chipbreaker
DJ
chipbreaker
Stainless steels, low-carbon steels, low-alloy steels, etc.
Medium to high carbon steels, alloy steels, etc.
Chip shape produced with peripheral insert
• Chip problems such as entangling are mainly caused by chips pro-
duced with the peripheral insert. These problems are dependent
on the types of Workpiece material and the cutting conditions.
• As shown below, when the feed is extremely low, the chips jump
over the chipbreaker groove and the continuously long chips may
wrap around the drill body.
• When the feed is too high, the chips increase in thickness and can
not be curled.
• Therefore, it is important to select proper cutting conditions to suit
the machining so that well controlled chips will be formed.
Typical chip shapes of general steels
As shown below, several turns of coil are an ideal shape.
As the feed increases, the curl radius and the number of turns tend to decrease.
Variation of chip shapes relating to feeds
• When machining long-chip materials such as stainless steels and mild steels, the wrong selection of cutting conditions re-
sults in chip entangling and tool breakage at worst. Therefore, cutting conditions should be carefully selected.
• “C” shaped, continuous coils of several to ten turns having adequately divided lengths are the ideal shape.
Ideal chip shapes
For machining stainless steels or low carbon steels,
DS chipbreaker is recommended.
When using a TDX drill in tool-rotating condition, DS
chipbreaker produces compact chips and allows more
stable machining than DJ chipbreaker. When using
it in work-rotating condition, DS chipbreaker pro-
vides outstanding affect on chip control.
Dr i l l ing Tool s