Unknown - page 1302

G056
User´s Guide
User ’s
Gu ide-
Techn i ca l Reference
Troubleshoot ing in gun dr i l l ing
Dr i l l ing Tool s
Problem
Cause
Countermeasure
Machine
Clamping the workpiece is unstable.
Clamp the workpiece firmly.
The type of coolant is not appropriate.
Use water-insoluble coolant.
Foreign material is in the coolant.
Thoroughly filtrate the coolant (Use a filter
with the filtration accuracy in 10µm or less).
The run-out of the spindle is too large.
Minimize the run-out of the spindle.
The clearance between the guide bush
and the drill is not appropriate.
Replace the guide bush (The clearance
should be between +0.003 and +0.008).
The feed speed (Vf) varies.
Use mechanical feed.
The number of revolutions varies
(decreases).
Increase the machine power or adjust the
cutting conditions.
Drill
Abnormal damage occurs.
See “Short tool life” for the details.
Regrinding is in poor quality.
Make sure no damage is left on the drill
and that the cutting edge geometry is not
changed.
Cutting condition
The feed (f) is too high.
Reduce the feed.
Others
Chip packing occurs.
See “Chip packing” for the details.
Machine
The clearance between the guide bush
and the drill is not appropriate.
Replace the guide bush (The clearance
should be between +0.003 and +0.008).
The guide bush is apart from the
workpiece surface at the entry.
Contact the guide bush closely with the
workpiece.
The type of coolant is not appropriate.
Use water-insoluble coolant.
The concentricity of the guide bush and
the spindle is too large.
Decrease the concentricity of the guide
bush and the spindle.
Drill
Abnormal damage occurs.
See “Short tool life” for the details.
Regrinding is in poor quality.
Make sure no damage is left on the drill
and that the cutting edge geometry is not
changed.
Cutting condition
The feed (f) is not suitable.
Use an appropriate feed.
Workpiece
Interrupted or cross drilling is required.
Change the tool to a standard gundrill.
Others
Chip packing occurs.
See “Chip packing” for the details.
Machine
Clamping the workpiece is unstable.
Clamp the workpiece firmly.
The guide bush is apart from the
workpiece surface at the entry.
Contact the guide bush closely with the
workpiece.
The concentricity of the guide bush and
the spindle is too large.
Decrease the concentricity of the guide
bush and the spindle.
The clearance between the guide bush
and the drill is not appropriate.
Replace the guide bush (The clearance
should be between +0.003 and +0.008).
Drill
The selection of the guide pads is not
suitable.
Use 2 guide pads instead of 3.
Regrinding is in poor quality.
Make sure no damage is left on the drill
and that the cutting edge geometry is not
changed.
Cutting condition
The feed (f) is too high.
Reduce the feed.
Workpiece
The workpiece has blow holes or
unevenness.
Use the workpiece without defect.
The workpiece surface is slanted at the
entry.
Use low feed.
Interrupted or cross drilling is required.
Change the tool to a standard gundrill.
Rough surface finish
Unacceptable circularity, cyndricity,
and oversize
Bending of hole
Hole accuracy
1...,1292,1293,1294,1295,1296,1297,1298,1299,1300,1301 1303,1304,1305,1306,1307,1308,1309,1310,1311,1312,...1348
Powered by FlippingBook