G057
User´s Guide
Tungaloy
User ’s
Gu ide-
Techn i ca l Reference
Troubleshoot ing in gun dr i l l ing
Dr i l l ing Tool s
Problem
Cause
Countermeasure
Machine
The type of coolant is not appropriate.
Use water-insoluble coolant.
Foreign material is in the coolant.
Thoroughly filtrate the coolant (Use a filter
with the filtration accuracy in 10µm or less).
The clearance between the guide bush
and the drill is not appropriate.
Replace the guide bush (The clearance
should be between +0.003 and +0.008).
Whipping effect occurs.
Place a whip guide at the appropriate
position.
The concentricity of the guide bush and
the spindle is too large.
Decrease the concentricity of the guide
bush and the spindle.
The coolant temperature is too high.
Increase the capacity of the tank.
Drill
The selection of the guide pads is not
suitable.
Use 2 guide pads instead of 3.
Regrinding is in poor quality.
Make sure no damage is left on the drill
and that the cutting edge geometry is not
changed.
The drill's overall length is excessive.
Reduce the drill’s overall length.
Excessive wear occurs and the chip shape
changes.
Regrind the gundrill (ease the tool life
criteria).
Cutting condition
The cutting speed (Vc) is too high.
Reduce the cutting speed.
The feed (f) is too high.
Reduce the feed.
The coolant pressure is not high enough.
Increase the coolant pressure.
Workpiece
The material quality varies.
Reduce the cutting speed (Vc).
Machine
The shape of the guide bush is not
suitable.
Modify the tip of the guide bush to match
the shape of the workpiece surface at the
entry.
The number of revolutions varies
(decreases).
Increase the machine power or adjust the
cutting conditions.
The chip box is too small for smooth chip
evacuation.
Enlarge the chip box.
Cutting condition
The feed (f) is not suitable.
Use an appropriate feed.
The coolant pressure is not high enough.
Increase the coolant pressure.
Workpiece
Interrupted or cross drilling is required.
Change the tool to a standard gundrill.
The operation is for stacked plates.
Change the cutting edge shape so that the
cores become small.
The material quality varies.
Increase the feed.
Drill
The cutting edge is fractured or chipped.
See “Breakage” for the details.
Wear on the outer corner is excessive.
Regrind the gundrill (ease the tool life
criteria).
Cutting condition
The feed (f) is too low.
Increase the feed.
Workpiece
Drilling a center hole is required.
Make the center hole as small as the drill
diameter and increase the coolant pressure.
Short tool life
Chip control
Abnormal wear
Chip packing
Chip
entanglement