D252
Multi Function
WRENCH
OK
CAUTIONARY POINTS IN USE
· The cutting heads specified by Tungaloy must be used. Avoid using alternate
heads that are not Tungaloy products as this will damage the shank and can
cause severe accident or injury.
· Before setting the head, clean the connection screw with an air blast or a wiping
cloth to remove chips and other foreign matter that may remain.
· Do not apply the lubricant to the connection screw.
· Please use the correct “Wrench” with the correct cutting head. Tighten the head
slowly until the face of the head contacts the shank. (Please refer to the picture
shown on the right.) Re-tightening or over-tightening is not required. Excessive
tightening may cause the cutting head to break.
· Do not apply excessive force or a hammer when tightening or exchanging the
cutting heads.
Appearance
Designation
Connection
screw size
Torque (N·m)
Applicable head
KEYV-S05
S05
7
Square
Ball
Radius
Drilling
Chamfering
Counter boring
KEYV-S06
S06
10
KEYV-S08
S08
15
KEYV-S10
S10
28
KEYV-S12
S12
28
KEYV-W20
S15
40
KEYV-177
S06
10
Slotting VST type
KEYV-217
S08
15
KEYV-T40L
S08
15
Slotting VST, VTB type
S10
28
KEYV-T20
S05
7
Slotting VTB type
S06
10
KEYV-T25
S06
10
KEYV-T30L
S08
15
KEYV-T50L
S08
15
S10
28
Note: Optional parts
Gap