D132
Face Milling
To achieve a good surface finish, a wiper insert is recommended.
(PNCU0905GNER-W)
When using the wiper insert, install the insert as shown in Fig. C.
Ensure that the groove is at the front as shown in Fig. D.
The wiper insert has two wiping corners. (Fig. D)
Do not use the other corners. It may break the tool body.
NOTES ON USE OF WIPER INSERT
Mark
Cutting
edge
Cutting
edge
Groove
Installation of the extra close pitch cutter inserts
The extra close pitch cutter has a slanted screw.
Locate insert and then fasten the screw. (Fig. A)
Appropriate torque is 3.5 N·m.
After fastening the screw, please ensure there is no space
between the cutter body and insert. (Fig. B)
Locate insert
and then fasten
the screw.
Fig. C
Fig. D
Fig. A
Fig. B