D022
High-Feed Milling
STANDARD CUTTING CONDITIONS
· Slot or pocket milling is not recommended, since the chip re-cutting easily
occurs.
· Tool overhang length must be as short as possible to avoid chatter. When
the tool overhang length is long, decrease the number of revolutions and feed.
· Cutting conditions are generally limited by the rigidity and power of the
machine and the rigidity of the workpiece. When setting the conditions, start
from half of the values of the standard cutting conditions and then increase
the value gradually while making sure the machine is running normally.
ISO
Workpiece material
Hardness
Priority
Grade Cutting speed
Vc (m/min)
Feed per tooth
fz (mm/t)
High carbon steels
C45, etc.
~ 300HB
First choice
AH725
100 - 300
0.5 - 2
For wear resistance
T3130
100 - 300
0.5 - 2
For impact resistance
AH130
100 - 300
0.5 - 2
Alloyed steels
42CrMo4, etc.
~ 300HB
First choice
AH725
100 - 200
0.5 - 1.5
For wear resistance
T3130
100 - 200
0.5 - 1.5
For impact resistance
AH130
100 - 200
0.5 - 1.5
Prehardened steels
PX5, NAK80, etc.
30 ~ 40HRC
-
AH725
100 - 200
0.5 - 1
Stainless steel
X5CrNi18-9, etc.
~ 200HB
-
AH130
100 - 150
0.3 - 0.8
Grey cast iron
250, etc.
-
-
AH120
100 - 300
0.5 - 2
Ductile cast irons
600-3, etc.
-
-
AH120
80 - 200
0.5 - 2
Titanium alloy
Ti-6AI-4V, etc.
~ 40HRC
-
AH725
30 - 60
0.3 - 0.7
Hardened steels
X40CrMoV5-1, etc.
40 ~ 50HRC
-
AH725
80 - 130
0.1 - 0.3
50 ~ 60HRC
-
AH725
50 - 70
0.03 - 0.07