E050
2-e ective Drill
STANDARD CUTTING CONDITIONS
ISO Workpiece material
Cutting speed:
Vc
(m/min)
Feed: f (mm/rev)
ø0.1 ~ ø0.3 ø0.3 ~ ø0.5 ø0.5 ~ ø3 ø0.1 ~ ø0.3 ø0.3 ~ ø0.5 ø0.5 ~ ø1 ø1 ~ ø2 ø2 ~ ø3
Carbon and alloy steels
5 - 20
15 - 30
25 - 60 0.001 - 0.004 0.002 - 0.01 0.005 - 0.05 0.03 - 0.09 0.05 - 0.1
Stainless steels
2 - 12
6 - 18
10 - 20 0.0005 - 0.004 0.002 - 0.008 0.005 - 0.03 0.01 - 0.04 0.02 - 0.05
Grey cast irons
5 - 15
10 - 25
20 - 50 0.0005 - 0.004 0.002- 0.012 0.005 - 0.03 0.01 - 0.06 0.03 - 0.12
Ductile cast irons
5 - 15
10 - 25
20 - 50 0.001 - 0.003 0.002 - 0.01 0.005 - 0.02 0.01 - 0.05 0.03 - 0.1
Aluminium alloys
10 - 20
10 - 30
20 - 50 0.001 - 0.01 0.005 - 0.03 0.01 - 0.05 0.04 - 0.15 0.06 - 0.2
Copper / Brass
10 - 20
10 - 30
20 - 50 0.001 - 0.01 0.005 - 0.03 0.01 - 0.05 0.04 - 0.15 0.06 - 0.2
Heat-resistant alloys
2 - 6
5 - 10
8 - 20 0.0005 - 0.003 0.002 - 0.004 0.002 - 0.004 0.002 - 0.004
Not
recommended
High hardened steels
4 - 8
6 - 10
6 - 16 0.0005 - 0.002 0.001 - 0.005 0.005 - 0.02 0.01 - 0.03 0.02 - 0.06
Note:
• When the drilling depth is deeper than L/D = 5, use drill pecking every 10
to 50% of the drill diameter.
• The above cutting conditions are applied to when a water soluble cutting
fluid is used. For drilling a hole smaller than ø0.3 mm, use of a starting
drill is recommended.
• When setting the drill, the drill run out should be within 0.002 mm on the
taper. (Especially for the drill diameter smaller than ø0.5 mm)