Unknown - page 969

E019
Tungaloy
2-e•ective Drill
➀
➁
➂
➃
8 x D,12 x D
0.5 x D
0.5 x D
0.5 x D
CAUTION FOR USING DRILLS WITH L /D = 8, 12
➀
Place the TIDC drill body into the chamfer adaptor without
chamfer inserts.
➁
Adjust the overhang length of the drill body with the adjust-
ing screw at the bottom of the adaptor.
➂
Adjust the position of the drill body so that the drill body
is fixed at the cotter and tighten the clamping screw of the
drill body. This aligns the flutes of the TIDC drill body with
the chamfer inserts.
➃
To clamp the chamfer inserts, tighten the clamping screw of
the insert while pushing the insert into the insert pocket.
The overhang length of the drill can be changed by the adjusting screw at the bottom
of the adaptor.
The rear end of the drill body must be in contact with the adjusting screw as the screw
supports the drill against thrust force when drilling.
Notice
Before removing the drill body from the
adaptor, chamfer inserts must be un-
clamped.
The overhang adjusting screw can be han-
dled from the top of the adaptor with flat-
blade screwdriver. In this way, the overhang
length of the drill body can be adjusted after
the adaptor is positioned on the drill shank.
➀
Insert the drill body into
chamfering adaptor
Procedure
Cotter
➃
Clamp the chamfer
inserts
➂
Clamp the drill body
Clamping screw of
TIDC drill body
➁
Adjust the overhang length
with screw
Overhang adjusting
screw
HOW TO MOUNT THE TIDC DRILL BODY INTO THE CHAMFER ADAPTOR
Prior to using the drill with L/D = 8, 12 a pilot hole should be drilled with a
short or centering drill.
➀
Drill a pilot hole in the depth of 0.5 x D.
➁
Rotate the drill at a low speed, such as
100 min
-1
, and feed it slowly into the
pilot hole until the drill reaches several
millimeters from the bottom.
➂
Supply the coolant and rotate the drill
at the recommended speed.
➃
Drill the required depth under the rec-
ommended cutting conditions.
1...,959,960,961,962,963,964,965,966,967,968 970,971,972,973,974,975,976,977,978,979,...1348
Powered by FlippingBook