E017
Tungaloy
2-eective Drill
TID /TIDC / DMP
TECHNICAL GUIDELINES
0
0
0.2 -
0.3 mm
ø = ø
D
c
Ra
ø < ø
D
c - 0.03 mm
ø > ø
D
c + 0.15 mm
P P x 1.25
30
20
10
5
8
12
16
20
26
8
12
16
20
26
1.75
1.5
1.25
1
0.75
0.5
0.25
L/D = 1.5, 3
L/D = 5
L/D = 8
L/D = 12
When to change drill heads (Criteria for the end of tool life)
How to clamp the drill head
Coolant supply
The criteria to identify the time for tool change are as follows:
➀
Clean and lubricate the pocket.
➁
Set the drill head into the pocket.
➂
Set the clamping key on the drill head
➃
Clamp
Internal coolant supply is recom-
mended.
Air blast etc.
The required coolant flow and pressure
Width of corner wear
reaches 0.2 – 0.3 mm.
Spindle load exceeds
125% of the normal value.
Hole diameter is 0.15 mm
larger or 0.03 mm smaller
than the drill diameter.
Surface roughness dete-
riorates.
Vibration or unusual
noise occurs.
Drill diameter: øDc (mm)
Coolant flow Q (liter/min)
Drill diameter: øDc (mm)
Coolant pressure (MPa)