E099
Tungaloy
Indexable Drill
STANDARD CUTTING CONDITIONS
ISO Workpiece
material
Cutting speed
Vc (m/min)
Feed
f (mm/rev)
Carbon steel
60 - 70
0.07 - 0.17
Alloy steel
60 - 70
0.07 - 0.17
Cast iron
70 - 100
0.1 - 0.2
Note: øDc
≦
ø37 mm, feed should be set less than 0.13 mm/rev for
steel, 0.15 mm/rev for cast iron.
Number of revolutions n (min-1) = Cutting speed Vc ×1000×3.14÷Tool diameter øDc
Feed speed Vf (mm/min) = No. of revolutions n (min-1) ×Feed per revolution f (mm/rev)
• When drilling steel, a water soluble coolant should be used. Coolant pressure of 1
MPa or higher and quantity of 10 litter/min or more are essential.
•For tool-rotating applications with TDP60-65 65-70, please check the availability of
holders. Since its shank dia is 50mm.
•Drilling into stacked plates is not recommended.
•Not suitable for low carbon steels and stainless steels, because of chip control
issues.
Caut ionar y points in use