Unknown - page 1041

E091
Tungaloy
Indexable Drill
øD
1
øD
2
øD
3
R
2
R
4
R
3
R
1
Designation
øD
1
øD
2
øD
3
ℓ
1
ℓ
2
ℓ
3
ℓ
4
EZ2025
20
25
46
49
5
32.5
4
EZ2532
25
32
51
52
5
38
4
EZ3240
32
40
54
62
5
43
4
EZ4050
40
50
69
63
5
55
4
SPARE PARTS
Designation
Wrench
EZ...
P-2.5
EZ s l eeve
Eccentric sleeves for "TungDrillTwisted" & "TungSix-Drill"
(+)
(-)
Use EZ sleeves for the following purposes
Hole diameter adjustment on the milling machine
Adjusting the finishing diameter when milling
Adjusting the finishing diameter in tool-rotating
applications such as on machining centres and
milling machines:
By using
EZ sleeve
, the finishing diameter can be
adjusted in the range from
+0.6 mm to -0.2 mm
.
Adjusting cutting edge height on lathe
Lathe
Adjusting of the cutting edge height in work rotat-
ing applications such as on lathes:
By using
EZ sleeve
, the cutting edge height can be adjusted in the range
from
+0.3 mm to -0.2 mm
. It results in eliminating troubles caused by im-
proper cutting-edge height.
Scale for adjusting finishing diameter
in milling (Periphery of sleeve)
Scale for adjusting cutting edge height
in turning (Front face of sleeve)
Setting of EZ sleeve
Cautious points
●
Can not be used for collect chuck holders.
●
Over L/D 4 or bigger adjustment, please reduce feed.
●
For smaller adjustment, the drill itself will interfere with the
hole diameter. It is recommended that hole diameter should
be adjusted to a larger diameter than the drill diameter.
When rotating the EZ sleeve, insert the wrench into the
hole at the flange periphery and rotate the EZ sleeve.
Screws A + B have to be loosened.
Secure the drill by screw A. Secure the EZ sleeve by light-
ly tightening screw B.
Tighten screw B only lightly otherwise EZ sleeve can be damaged!
Adjusting finishing diameter in milling
Adjusting cutting edge height on lathe
Align the graduated scale
on the periphery of the EZ
sleeve with the center of
the flat of the drill flange.
In the Figure shown below,
the sleeve is set so that the
finishing diameter will be
increased by 0.4 mm.
As shown in the Figure
below, set the EZ sleeve
between the drill shank
and the toolholder.
As shown in the Figure
below, set the EZ sleeve
between the drill shank
and the toolblock.
Align the graduated scale on
the front face of the Esleeve
with the center of the flat of
the drill flange.
In the Figure shown below, the
sleeve is set so that the center
of the drill will shift by 0.1 mm
to the plus (+) direction.
EZ sleeve
Flat
Flange
Fixing bolt “A”
Flat
Flange
EZ sleeve
Fixing bolt “B”
X-axis of
machine
+0.4 +0.2
Fixing bolt “A”
Fixing bolt “B”
1...,1031,1032,1033,1034,1035,1036,1037,1038,1039,1040 1042,1043,1044,1045,1046,1047,1048,1049,1050,1051,...1348
Powered by FlippingBook