Unknown - page 674

D082
Shoulder Milling
STANDARD CUTTING CONDITIONS
· To remove excessive chip accumulation use an air blast.
· When cutting an interrupted surface or a casted skin, the feed per tooth (
f
z) should
be reduced to the lower recommended value shown in the above table.
· Cutting conditions are limited by machine power, work piece rigidity and spindle
output. When the cutting width, depth or over hang length is large, set
V
c and
f
z to
the lower recommended values and check the machine power and vibration.
ISO
- 200
AH725
100 - 250
0.1 - 0.25
200 - 300
AH725
100 - 230
0.1 - 0.2
150 - 300
AH725
100 - 230
0.1 - 0.2
- 300
AH725
100 - 180
0.1 - 0.2
-
AH140
90 - 180
0.1
- 0.25
150 - 250
AH120
140 - 250
0.1 - 0.25
150 - 250
AH120
110 - 200
0.1 - 0.25
-
AH725
20 - 50
0.08 - 0.2
Hardness
HB
Low carbon steel
C15E, etc.
High carbon steel
C45, C55, etc.
Alloy steel
42CrMo4, etc.
Tool steel
X153CrMoV12, etc.
Stainless steel
X5CrNi18-9, etc.
Grey cast iron
250, etc.
Ductile cast iron
450-10S, etc.
Superalloys
Inconel 718, Ti-6Al-4V, etc.
Cutting speed
Vc (m/min)
Feed per tooth
fz (mm/t)
Workpiece material
Grade
1...,664,665,666,667,668,669,670,671,672,673 675,676,677,678,679,680,681,682,683,684,...1348
Powered by FlippingBook