D078
Shoulder Milling
ød
ød
ød1
Face mill arbors with center through-coolant hole
50/63 80
100
125
160
22
25.4 31.75 38.1 50.8
FMH22 FMH25.4 FMH31.75 FMH38.1 FMH50.8
Cutter diameter
ø
D
(mm)
Nominal diameter
ø
d
(mm)
Arbor type
3 holes equally
spaced
Notes on arbors: when using TAW13 or TPW13 type, use through center air.
16
22
25.4 31.75 38.1 50.8
SMA
SM1
FMC
SM1
FMA
FMC
FMA
SMB FMA FMA
4 ~ 6 5 ~ 8 6 ~ 9 10 ~ 13 10 ~ 15 10 ~ 15
Nominal diameter
ø
d
(mm)
Applicable arbor
types
Through hole diameter
ø
d
1
(mm)
When using the TAW13 or TPW13 type with through center air (coolant or
mist), the correct arbor must be used with through center air supplying.
■
Cautionary notes in use
In slotting or pocketing, when chips are likely to remain in the
cutting zone, internal air supplying or air blow is recommended to
prevent chip recutting.
Use of inserts other than those specified, can result in poor
cutting and cause damage to the cutter body. Therefore, specified
inserts from the Tungaloy catalogue must be used.
Before changing or indexing the inserts, remove chips or other
foreign matter from the insert, insert pocket and cutter body by
using an air blast or cloth.
The inserts should be clamped by using the wrench supplied
with the TAC Mill.
After a long period of use, the clamping screws and wrench may
become deformed or damaged. These elements must be replaced
as soon as possible.