C137
Tungaloy
Grooving Tool
01
10
20
30 01
10
20
30
UX30
NS9530
T313V
STANDARD CUTTING CONDITIONS
Grade selection guide
Grades
Main applications
Low to medium speed cutting of steel, cast steel,
cast iron and stainless steel
Medium to high speed cutting of steel and alloy
steel, with satisfactory surface finish
Low to high speed cutting of steel, cast steel,
cast iron and stainless steel
Standard cutting conditions
P group
K group
3
4
5
6
8
70 ~ 150
70 ~ 150
70 ~ 120
70 ~ 120
50 ~ 100
0.05 ~ 0.15
0.05 ~ 0.2
0.05 ~ 0.15
0.05 ~ 0.15
0.05 ~ 0.1
Workpiece
material:
General carbon steel, C45
Cutting fluid:
Water soluble cutting fluid
Groove width:
W
(mm)
Cutting speed
v
c
(m/min)
Feed
f
(mm/rev)
Notes on cutting diameter
• SA~SG types can widen the groove outward infinitely
after grooving from the minimum to maximum diameter.
• SF and SG types can widen the groove inward to
minimum zero after grooving from the minimum to
maximum diameter. (See the figure)
• SA~SE types can not be used to widen the groove
more inward from the minimum diameter.
Notes:
• Above cutting conditions are applied to the shallow groove type
(groove depth 10 ~ 16 mm).
• In the case of a deep groove type (groove depth 20 ~ 26 mm), apply
60 ~ 70% of above cutting conditions.
• The use of water soluble cutting fluid is recommended to discharge
chips, protect the finished surface, and prevent chipping.
Infinitely large
Max cutting diameter
to zero
Min cutting diameter