All prices quoted are non-binding recommended prices. 3/70 Design: With direct holding fixture. The steel body and spiral ring are dropforged. The front side is flattened at the edges up to size 315 mm, thereby reducing weight inertia and mass inertia. Application: For use on lathes, rotary tables, indexing devices etc., where high clamping forces and high concentricity and accurate repetition are required. Scope of delivery: Four-jaw lathe chuck with one set each of drilling jaws and turning jaws, chuck key and fixing bolts. Size A mm Short taper Taper size B mm Through-hole ∅ E mm Height without jaws D Concentricity mm max. rpm rpm 3122 Order No. € 125 4 63.5 32 56 0.03 5500 C◊ …0019 160 4 63.5 42 65 0.03 4600 1055.00 …0021 160 5 82.5 42 65 0.03 4600 1055.00 …0023 200 5 82.5 55 73.5 0.04 4000 1160.00 …0025 200 6 106.4 55 73.5 0.04 4000 1160.00 …0027 250 6 106.4 76 82 0.04 3000 1690.00 B …0029 250 8 139.7 76 82 0.04 3000 1690.00 B …0031 315 6 106.4 103 95 0.05 2300 C◊ B …0033 315 8 139.7 103 95 0.05 2300 C◊ B …0035 315 11 196.9 103 95 0.05 2300 C◊ B …0037 400 8 139.7 136 105 0.06 1800 C◊ B …0039 400 11 196.9 136 105 0.06 1800 C◊ B …0041 (W301) Spiral ring four-jaw chuck, DURO-M m DIN 55027 with retention stud and collar nut Design: Outward stepped, hardened. Application: As replacement drilling jaw for three-/four-jaw lathe chuck. Size mm Jaw length mm Jaw width mm Jaw height mm 3024 3036 3038 Order No. 3-piece 3-piece 4-piece € € € 80 37 12 26 125.00 153.50 205.00 …0080 100/ 110 48 14 33.5 125.00 153.50 205.00 …0100 125 52 18 41.5 125.00 153.50 205.00 …0125 160 61 18 47.5 138.00 170.00 226.00 …0160 200 69 20 53.5 162.50 199.50 266.50 …0200 250 90 24 67.5 189.50 234.00 311.00 …0250 315 130 34 79.5 285.00 350.50 465.00 …0315 350/ 400 130 34 79.5 – 583.00 C◊ …0400 500/ 630 190 42 95 – C◊ C◊ …5063 (W300) (W301) (W301) Drilling jaw Retrospectively covered stepped jaws must be ground in the chuck. 3024 3-piece set. 3036 3-piece set. 3038 4-piece set. A Lathe chucks 3.2
RkJQdWJsaXNoZXIy NTg4MTI=