C104
A'
A
0.1
0.03
0.02
0.01
0
0.2
0.3
Grooving Tool
h
b
f
Max. 14mm
w
5°
25
5
45
ar
48.5
h
1
h
1
h
L
1
2°
2°
2020
shank shown
Designation
W
ar
h
b
L
1
h
1
f
Insert
Shank
Blade
CGWSR/L2020-FLR/L3GP
3
10
20
20
152
20
27 FLEX30R/L CGWSR/L2020 FLR/L3GP
CGWSR/L2525-FLR/L3GP
3
10
25
25
152
25
32 FLEX30R/L CGWSR/L2525 FLR/L3GP
CGWSR/L2020-FLR/L4GP
4
12
20
20
152
20
27 FLEX40R/L CGWSR/L2020 FLR/L4GP
CGWSR/L2525-FLR/L4GP
4
12
25
25
152
25
32 FLEX40R/L CGWSR/L2525 FLR/L4GP
CGWSR/L2020-FLR/L5GP
5
14
20
20
152
20
27 FLEX50R/L CGWSR/L2020 FLR/L5GP
CGWSR/L2525-FLR/L5GP
5
14
25
25
152
25
32 FLEX50R/L CGWSR/L2525 FLR/L5GP
• When ordering, shank and blade ass'y Cat. No. or shank and blade-set are required.
• When using a right or left hand blade-set, the right hand blade-set is used with right hand shank and the left hand blade-set is used with left hand shank.
CGWSR/L-FLR/L#GP
External toolholders for grooving & turning
SPARE PARTS
Designation
Clamping screw Blade screw Wrench
CGWSR/L****-FLR/L*GP CHHM5-18
CSHB-6
P-4
Right hand (R) shown.
Feed direction
Front cutting edge
Feed: (mm/rev)
Correction value for
outer diameter (mm)
When performing OD machining, the tool point must be set at a right angle to the axial
direction of the work.
• When replacing an insert, the replacement should be made only after completely
removing any chips or other foreign matter from the tool clamping area on the
holder by using compressed air, etc.
• Never tighten the insert mounting screws when an insert has not been installed
since doing so can deform the screws and prevent the future installation of an
insert.
• Flex-Tool has mechanism in which the end cutting edge angle is formed by
accepting a cutting force. In external grooving, there is a possibility that if the cutting
conditions (feed and depth of cut) are set too high, the programmed diameter will
not be achieved. To prevent this problem, it is necessary to perform a compensation
in the program by an amount that is equal to the amount A'-A that is shown in the
drawing on the right. The values of compensation corresponding to the feeds are
also shown in the graph.
The length of blade for 5mm width is shortened 2mm compared from the old type
blade. Please notice and read the instruction manual packaged in the box.
Correction value for outer diameter (Reference)
Cautionary Notes