2/81 Keyway broaches Error diagnosis Poor surface quality: • Material is too soft • Wrong alignment of the broach • Cooling lubricant is not correctly applied • Wrong coolant lubrication • Blunt or badly sharpened teeth In the case of scoring: • Strip teeth/broach too sharp • Cooling lubricant is not correctly applied • Wrong coolant lubrication • Low machining speed • Blunt or badly sharpened teeth • Incorrect distance of teeth In the case of excessive wear at the edges: • Wear-promoting workpiece material • Cooling lubricant is not correctly applied • Wrong coolant lubrication • Machining speed too high • Wrong tool material If the broached groove runs out: • Wrong alignment of the broach • Material is too soft • Blunt or badly sharpened teeth Simple application: All you need is a press (dome press). No expensive special machinery for keyway broaching is required. A mechanical mandrel press or hydraulic press, which almost every company has, is best suited for broaching. There are 6 different back widths I to VI available for keyway widths from 2 to 25 mm; these are engraved on the broaches and the guide bushings. Each type "I" needle fits into each type "I" bushing, each type "II" needle fits into a type "II" bushing, etc. The bushings are available for every back width in the most common diameters from 6 to 150 mm. When larger broaches are used, several passes will be necessary to achieve the required keyway depth. Shims are supplied with these broaches for this purpose. The first operation is to be executed as described in the paragraph above, then the broach is cleaned of chips. Next, place a shim into the guiding groove, insert the broach and drive the broach through the workpiece again. Lubrication is very important, and the broach should be supplied with cutting oil of a high quality or coolant lubrication during the whole broaching process. Take the guide bushing which corresponds to the bore diameter in the workpiece (Fig. 1). Then select the broach with the corresponding tooth width (available in tolerance JS9 and P9) and slide it into the guide groove of the bushing (Fig. 2). It must slide freely until the first tooth is located on the workpiece. Now place the unit (the workpiece/ bushing/broach) under the pressing ram. Once you have ensured that the broach is centred both - vertically and horizontally, then drive the broach directly through the workpiece (Fig. 3). Broaching tools 22.6
RkJQdWJsaXNoZXIy NTg4MTI=