FORMAT_EN_2023-25_WCT_Light

1/264 Tooth pitch describes the number of teeth per inch (TPI). 1 inch is equivalent to 25.4 mm. A distinction is made between constant tooth pitch with a uniform tooth spacing, e.g. 2 teeth per inch and a variable tooth pitch with a different tooth spacing within an interval. Variable tooth pitches e.g. 2-3 teeth per inch are identified by two measured values: 2 teeth per inch is the maximum tooth spacing and 3 teeth per inch the minimum tooth spacing in the interval. Type of tooth The decisive size for selecting the tooth pitch is the intervention working length of the band saw blade in the workpiece. The table shows the respective upper and lower limits. Working length Variable Working length Type of tooth mm TPI from to 10 –14 ​ 20 8 –12 10 30 6 –10 20 50 5 – 8 30 60 4 – 6 50 90 3 – 4 80 150 2 – 3 120 300 1.4 – 2 250 600 1.0 – 1.4 400 1000 0.85– 1.15 600 2000 0.75– 1.25 600 2000 0.7 – 1 1000 3000 The offset, with the teeth protruding alternately to the left and right above the plane of the band body, enables bimetallic band saw blades to cut free of the saw band. Offset Sharp cutting edges with extremely small edge radii are the optimum prerequisite for high cutting performance life. This is guaranteed by correctly breaking in the saw bands, see figures above: 1. New cutting edge with very small edge radius 2. Optimally rounded cutting edge due to correct breaking in. 3. Incorrect breaking in leads to micro-chipping at the cutting edge. Before first use The band tension should be 300 N/mm2, check and adjust the oil content of the cooling lubricant using a hand refractometer, the recommended oil content of the cooling lubricant can be found in the cutting data sliders or in ParaMaster® 4.0. • C orrect cutting speed and feed rate (e.g. with cutting data disc) on the basis of the material and cutting material present. • I mportant: Utilise a new cutting speed (m/minute) and approx. 50% of the feed speed (mm/minute). • V ery important: New saw blades can tend to vibrate and generate vibration sounds - remedy: reduce the cutting speed slightly again (m/minute). • F or small workpiece dimensions, machine approx. 300 cm2 of the surface of the cutting material for breaking the blade in. • I f large workpiece dimensions have to be processed, then we recommend to break in the blade for approx. 15 minutes. • A fter the breaking in process has been concluded, then the cutting speed (m/minute) is initially slowly increased to the determined value and then the feeding rate (mm/minute) is gradually increased to the previously determined value. Breaking in the saw blades Structure of a bimetal band saw blade The standard offset is universally applicable for cutting thicknesses from 5 mm upwards for steel, cast iron and hard non-ferrous metals. Constant tooth pitch: At least one tooth per interval as unlimited, the remaining teeth in the interval are recurrently set as left/right or in reverse order. 1) Carrier band made of alloyed tempered steel 2) HSS flat wire 3) Electron or laser beam welding Constant tooth pitch Variable tooth pitch 1) min. 2) max. 3) toothing interval Metal saw belts and metal saw blades 1.7

RkJQdWJsaXNoZXIy NTg4MTI=