FORMAT_EN_2023-25_WCT_Light

8/70 Tungsten carbide burrs for universal applications are suitable for fine and coarse machining on all the most important industrially used materials. They offer good machining performance and can be used across different materials. Tungsten carbide burrs for high-performance applications are suitable for fine and coarse machining. Material-specific tooth systems especially for coarse machining with extremely high machining performance, good guidance and considerably fewer vibrations. Suitable for machining steel, cast steel, rust free stainless steel, aluminium and non-ferrous metals. Specially designed for fine finishing with higher stock removal and surface finish in areas where mounted points are normally used, Suitable for machining steel, cast iron, stainless steel as well as hard non-ferrous metal and high-temperature metal up to a hardness of 68 HRC. Machining task Material groups Processing Universal application Page High-performance application Page Deburring, chamfering, milling in preparation for build-up welding, machining of weld seam, machining of contours, fettling of castings Steel, cast steel Steels up to 1200 N/mm2 (< 38 HRC) Coarse machining C 8/72-8/73 STEEL 8/79 3 PLUS 8/74 Fine machining 5 8/77-8/78 MICRO 8/71 Hardened, tempered steels above 1200 N/mm2 (> 38 HRC) Coarse machining C 8/72-8/73 STEEL 8/79 3 PLUS 8/74 3 8/75-8/76 Fine machining 5 8/77-8/78 MICRO 8/71 Stainless steel (INOX) Rust and acid resistant steels Coarse machining 3 8/75-8/76 INOX 8/80 Fine machining 5 8/77-8/78 MICRO 8/71 Non-ferrous metals Soft NF metals Coarse machining – ALU 8/78 Fine machining 3 8/75-8/76 Hard NF metals Coarse machining 3 8/75-8/76 ALU 8/78 – – INOX 8/80 Fine machining 5 8/77-8/78 MICRO 8/71 Heat-resistant materials Coarse machining 3 PLUS 8/74 MICRO 8/71 Fine machining 5 8/77-8/78 Cast iron Grey cast iron, white cast iron Coarse machining C 8/72-8/73 – – 3 PLUS 8/74 Fine machining 3 8/75-8/76 MICRO 8/71 Seaming, outline milling, making openings Synthetics, other materials Fibre-reinforced plastics (GFP/CFP), thermoplastic plastics, hard rubber Coarse machining – – ALU 8/78 Note: As an alternative for tooth system 4, tooth system C and 3 PLUS are recommended and as an alternative for tooth system Alu-Spezial, tooth system Alu is recommended. Note: The burr circumference in contact with the workpiece must not exceed 1/3 of the total circumference. Failure to observe this will result in unstable milling behaviour and possibly tooth chipping. Safety recommendations: Please wear appropriate eye protection, ear protection and protective gloves and observe the recommended speeds, especially for burrs with long shank! Tooth system C/3 PLUS Tooth system ALU Tooth system 3 Tooth system INOX Tooth system 5 Tooth system MICRO Tooth system STEEL Tungsten carbide burr Carbide burrs 8

RkJQdWJsaXNoZXIy NTg4MTI=